Force – 6902 – 1 x 4 Erbium-doped Fiber Amplifier – Discontinued

Sorry, this product has been discontinued. Please refer to this Fiber Amplifier.

  • Amplifies optical signals in post-amp power booster, in-line power amplifier, or pre-amp booster applications.
  • Provides low noise figures making these units ideal for CATV applications.
  • AC Power Supply Model complies with FCC and UL Requirements.
  • State-of-the-art 980 nm pump laser provides high optical output power.
  • A rear panel 9-pin D-sub connector inputs alarm information into a status monitoring system.
  • Front panel LEDs allow immediate visual verification of the units’ operational status.

Out of stock

SKU: 6902 Categories: ,

Description

The Force Model 6901 and 6902 provide unparalleled performance in post-amplifier, in-line amplifier, pre-amplifier applications. As a post amplifier, Model 6901 receives the transmitted signal at its origination and launches a data stream at +15.5 dBm typical over a single optical fiber, making it ideal for long-haul applications. As an in-line amplifier, Model 6901 increases the signal strength at some point in the transmission line, greatly increasing the allowable distance between the transmit and receive sites. As a pre-amplifier, the Model 6901 directly precedes the receiver, boosting signal strength. Model 6902 provides four outputs of +8.9 dBm via an integral optical 1 x 4 splitter, providing multiple signals for local distribution. The Models 6901 and 6902 will interface with a remote status monitoring system via a rear panel 9-pin D-sub connector, allowing the user to access system information from a distant location. The wide wavelength range, excellent gain flatness, and low noise figure make the EDFAs ideal for CATV and DWDM applications.

Open Spec Sheet